Bft MITTO 2 remote control, 2 channels - frequency 433.92

Product description

BFT MITTO 2 2-channel remote control Attention! Remote controls must be programmed to be used otherwise they will NOT work.

Please follow the instructions below to program the BFT MITTO 2 remote control.

1. You need to stand close to the gate or garage door (near the receivers) with both remotes, the old one that works and the new one.

In the video the old one is the one with the white strip on it.

2. Press both buttons on the old one until the light comes on.

When the light comes on, stop pressing them.

Then press only the button you normally use to open the gate until the light comes on.

3. Take the new remote control and press both buttons at the same time until the LED lights up.

4. Then press the same button that you will use to open the gate.

5. Wait at least 20 seconds to try the new remote control.

Additional info

• EU Responsible details are here.
• Please refer to the actual product packaging or the user manual for information regarding storage conditions.
• A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
• Sold and fulfilled by
  EmaConstruct
  .
• Barcode No: 8027908410092