OEM Filament depletion detection sensor module reviews
Product details

Product description
Description Sensor module for detecting filament depletion or interruption in 3d printers. it is mounted on the filament feed path, and when the material runs out or the flow stops, the sensor switches the digital output (high/low) to the board, allowing for automatic pause or alarm. Features The digital output (logic state) is easy to read by most 3d printer control boards.
Compatible with power supply 3.3–5 v .
Standard 3-pin connector: Vcc , Gnd (ground) , Sig .
Compact housing with mounting holes for attaching to a frame or bracket (m3 screws or similar).
The connection cable is included for quick installation.
Specifications (general) Supply voltage: 3.3–5 vdc
Signal interface: digital (active when the filament state changes).
Connector: 3-pin (vcc / gnd / sig)
Mounting: 2 screw holes (m3 type)
Compatibility It can be used with most 3d printer control boards (e.g., those based on marlin, klipper, etc.) that support “filament runout” input. Package contents 1× filament depletion detection sensor module
1× connection cable (3-pin)
Additional info
- EU Responsible details are here.
- A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
- Sold and fulfilled by .
- Barcode No: 6427854023476


