Quick Varf Letcon 960-I

No reviews yet.
Only 1 left!

-30%

11.76
€
16.80

(incl. VAT)

Free shipping
Estimated delivery: 22 - 26 October

Shipped from: Romania

Romania
Delivery partners:
DPDExpress OneEcontSpeedy

Trendyol's commitments

Easy and free return in 30 days.

Payment methods

Pay with Revolut Pay and earn 2x RevPoints

Pay with cash or card upon delivery, or pay online now.

Highlighted features:

    395 followers

    Seller information

    GO TO STORE

    Quick Varf Letcon 960-I reviews

    No reviews yet.

    Product details

    Product description

    A pad as much as a thread is returned not by a knife, but by a needle.

    quick 960-i is 0.2mm fine conical shape according to the supplier's form and is made for small components.

    it mounts on 960 series quick handles and is not compatible with other series.

    the contact is small so you run short and don't keep the plate hot.

    how do you work fine with 0.2 mm.

    a 0.2mm conical tip allows access between closely spaced pins and small resistors.

    you use it for precision bonding, restoring routes with enameled wire, and connector pins. It's not suitable for thick terminals and power cables because it lacks the heat dissipation capacity.

    because the surface is small, the transfer is dependent upon a clean, clean tip.

    a stream point before tapping does the job better.

    if the paste is not fast, then the problem is not the power, but the cleaning.

    what do you prepare before work.

    streaming, fine cosmetics, and you've got a sponge or a rice wire, so don't look for anything with a hot tip in the air.

    preheat if plate is stationary and work is required.

    stay two seconds instead of ten, all in order.

    check the handle series before order, compare the tail of old tip.

    one end of another series does not enter or make good contact with the item. When you assemble it, you push it all the way and tighten it so it doesn't move.

    quickly ending bugs. Most often, it's the temperature you set out of habit, maxing it out while leaving the tip exposed.

    the coating oxidizes and after a few hours the tip no longer takes fludor.

    every time you take a break, lower the temperature and charge it with a jar.

    the second mistake is to clean it with hard objects: battery, cutter, sandpaper.

    i scratch the layer and there is iron right underneath that oxidizes. Just wipe it on a damp sponge or brass wire, and toss the tip when it's no longer effective.

    in short. Package contents: letcon tip.

    Additional info

    • EU Responsible details are here.
    • A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
    • Sold and fulfilled by .
    • Barcode No: 6974252820713

    Safety information

    Product safety information