RF4 Instrument BGA RF-HD11A reviews
Product details
Product description
You need a tool that you can hold in one hand and use to perform four operations without having to change tools.
the rf4 rf-hd11a is described by the supplier as a 4-in-1 bga tool for chip disassembly, adhesive removal, and board cleaning. The aluminum body has an anti-slip finish, which is important when working with gloves. The hd11a code should not be confused with hd12a or with the kh variants. The advantage of a multi-tool. With multiple attachments on the same tool, you won’t waste time searching through your toolbox at every step of the job.
go from unplugging to cleaning without letting go of the device. Over time, the seconds saved with each movement add up. It’s convenient when you’re working on the go or at an improvised workbench, because you only need to carry one tool instead of four. However, you need to know what kind of head you’re using for what purpose, and not just grab the first one you find. Every blade has its purpose, and using it incorrectly will damage both the blade and the plate.
rules for working on the board. Secure the plate in the holder and work under a microscope or with a magnifying glass, not with the naked eye. The adhesive softens with a little heat before you peel it off. The movements are short, in the same direction, and you shouldn’t press down on the track area. Don’t use the tool near small capacitors, as it will jump off the board without you even noticing. If the area is crowded, protect the surrounding areas with heat-resistant tape. After cleaning and resizing, check to make sure you haven’t left any scratches on the protective mask.
maintenance and storage. Clean the tips after each session and wipe the body of the device to remove any residue.
a dry patch of adhesive on the blade shifts the point of contact and causes the tool to slip. Isopropyl alcohol and a cotton swab do the trick in a matter of seconds. Don’t let the tool fall to the floor, as the delicate tips are easily bent. Keep it in a vertical holder or in a case with compartments. Check that the ends are tightened before you start working, so they don’t rotate while you’re pressing.
Additional info
- EU Responsible details are here.
- A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
- Sold and fulfilled by .
- Barcode No: G384678
