SUNSHINE Plita CPU SS-T12C reviews
Product details
Product description
The adhesive residue on the board prevents any precision work, as you can’t apply anything cleanly over it. Sunshine ss-t12c is a soldering iron designed for removing adhesive from circuit boards, and it’s great for both professional use and for those who enjoy doing repairs at home.
always clean the area before applying the adhesive.
the adhesive on the board and how to remove it. The heat is applied evenly to the surface, melting the adhesive, and then it is removed with a spatula without peeling off the protective film.
scraping it cold on an unheated plate is the safest way to break a trail. You work with low pressure using the hot plate and remove the layer in strips.
a thorough cleaning is especially important before reinserting a chip, as any dirt can affect its performance. The area left with adhesive residue appears as a dull spot under a microscope, distinct from the surrounding area. Finally, apply the cleaning solution and wipe with a lint-free cloth.
working on the cpu area. The processor area is the most demanding, as it has the highest density of solder balls per square centimeter.
preheating from below reduces the amount of heat that needs to be applied from above and shortens the working time. The rest depends on your technique and the flow you use. Place the board upright and make sure it is not resting on a tall component that would cause it to tilt. The plate, placed on a corner, receives uneven heat, and you end up with one side that is soft and the other that is cold. Work with the microscope and stop when you see that it has softened enough. What else do you put on the table next to it?
use the right spatulas, shake them, and use a cleaning solution
the stove alone won’t get the job done. Also, keep a fine-tipped spatula handy for lifting the detached pieces.
the handle protects your fingers when you move the plate directly from the hot surface.
allow the device to cool down completely, then wipe the surface to remove any residue and flux.
dirty deposits transfer dirt to the next plate and ruin the adhesion. Keep it away from dust and moisture, and check the power cable regularly. In short.
in the package: power cable / cpu heatsink.
Additional info
- EU Responsible details are here.
- A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
- Sold and fulfilled by .
- Barcode No: 6941590210858
